These 10mm trench line models can also be used as 10mm embankments and earthworks.
10mm Trenches in 25mm Divisions
These 10mm-scale embankments are designed as models for marking trench lines in front of figure bases, especially for bases 25mm wide. One ‘division’ is a little over 25mm to be able to accommodate a 25mm-wide base.
The sections are designed to be finished off by having their embankments filled with a modelling compound or paste such as widely available spackle or grout filler.
Crenelated Trench Section T25-10mm-01
Each crenelated trench section has three full divisions and ends of half-wide divisions. The model is 113mm long.
50mm Position Trench Section T25-10mm-02
The position is a little over 50mm wide. The ends are half-wide divisions. The model, like T25-10mm-10, is a little over 84mm long.
Observation Trench Section T25-10mm-03
The observation trench is a little over 10mm wide. The ends are half-wide divisions.
Communication Trench Section T25-10mm-10
This straight communication trench model, like T25-10mm-02, is a little over 84mm long - equal to three divisions
Inward Wedge Trench Section T25-10mm-04
This wedge section is designed to add bends to trench lines or simply give them a more natural look.
Outward Wedge Trench Section T25-10mm-05
This wedge section is designed to add bends to trench lines or simply give them a more natural look. The model is one division wide.
Inward Corner Trench Section T25-10mm-06
This section can be used as a corner or as an end of a trench line. The model is half a division wide.
Outward Corner Trench Section T25-10mm-07
This section can be used as a corner or as a junction of a trench. The model is one division wide.
End Trench Section T25-10mm-08
As end sections these models have only one connecting end. Pack comes with one left and one right end section. The models are half a division wide.
L-Shape End Trench Section T25-10mm-09
As end sections these models have only one connecting end. Pack comes with one left and one right end section. The models are half a division wide.
The ‘connects’ – the end shapes where the sections connect – on each section are all the same shape. The outline of the shape follows the level of the ‘ground’ that should be sculpted with modelling paste. If the models are to be used as trenches, the ground level should not be lower than the walls of the trenches at the top of the walls.
10mm Trenches & Embankments
No comments:
Post a Comment